Chapter 47 Maintenance
GS3700/XGS3700 Series User’s Guide
450
47.3 Restore a Configuration File
Restore a previously saved configuration from your computer to the Switch using the Restore
Configuration screen.
Figure 341 Management > Maintenance > Restore Configuration
Click the Choose File button to upload the path and file name of the configuration file you wish to
restore in the File Path text box. After you have specified the file, click Restore. "config" is the
name of the configuration file on the Switch, so your backup configuration file is automatically
renamed when you restore using this screen.
Version The Switch has two firmware sets, Firm w are 1 and Firm w are 2, residing in flash.
• Running shows the version number (and model code) and MM/ DD/ YYYY creation date
of the firmware currently in use on the Switch (Firm w are 1 or Firm w are 2) . The
firmware information is also displayed at System Information in Basic Settings.
• Firmw are 1 shows its version number (and model code) and MM/ DD/YYYY creation
date.
• Firmw are 2 shows its version number (and model code) and MM/ DD/ YYYY creation
date.
Current Boot
Image
This displays which firmware is currently in use on the Switch (Firm w are 1 or Firm w are
2) .
Config Boot
Image
Select which firmware (Firmw are 1 or Firm w are 2) should load after rebooting. Click
Apply and reboot the Switch to see changes including in the Current Boot I mage field.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel
to save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
(Stacking mode) Click the drop-down list to choose the slot number of the Switch in a stack to upgrade the
firmware on this slot. Or select All to upgrade the firmware for all slots.
Firmware Choose to upload the new firmware to (Firmware) 1 or (Firmware) 2.
Choose File Click this and locate the path and file name of the firmware file you wish to upload to the
Switch.
Upgrade Click Upgrade to load the new firmware. Firmware upgrades are only applied after a
reboot. To reboot, go to Management > Maintenance > Reboot System. You may also
click Config 1, Config 2, or Factory Default (Config 1, Config 2 and Factory Default
are the configuration files you want the Switch to use when it restarts).
Table 223 Management > Maintenance> Firmware Upgrade (continued)
LABEL DESCRIPTION
To Next Page
Loading...
