Chapter 48 Access Control
GS3700/XGS3700 Series User’s Guide
469
48.3.7 Configuring SNMP User
From the SNMP screen, click User to view the screen as shown. Use the User screen to create
SNMP users for authentication with managers using SNMP v3 and associate them to SNMP groups.
An SNMP user is an SNMP manager.
Figure 354 Management > Access Control > SNMP > User
The following table describes the labels in this screen.
Port This field displays a port number. In stacking mode, the first number represents the slot
and the second the port number.
1/ * Settings in this row apply to all ports for the Switch represented by the slot ID (in stacking
mode).
Use this row only if you want to make some of the settings the same for all ports. Use this
row first to set the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Active Select this check box to enable the sending of SNMP traps on this port. The Switch sends
the related traps received on this port to the SNMP manager.
Clear this check box to disable the sending of SNMP traps on this port.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 238 Management > Access Control > SNMP > Trap Group > Port (continued)
LABEL DESCRIPTION
Table 239 Management > Access Control > SNMP > User
LABEL DESCRIPTION
User Information
Note: Use the username and password of the login accounts you specify in this screen to
create accounts on the SNMP v3 manager.
Username Specify the username of a login account on the Switch.
To Next Page
Loading...
