ZyXEL Communications GS3700 Series - Configuring SNMP

Chapter 48 Access Control
GS3700/XGS3700 Series User’s Guide
465
48.3.4 Configuring SNMP
From the Access Control screen, display the SNMP screen. You can click Access Control to go
back to the Access Control screen.
Figure 350 Management > Access Control > SNMP
Table 235 SNMP Switch Traps
OPTION OBJECT LABEL OBJECT ID DESCRIPTION
stp STPNewRoot 1.3.6.1.2.1.17.0.1 This trap is sent when the STP root switch
changes.
zyMrstpNewRoot 1.3.6.1.4.1.890.1.15.3.52.3.1 This trap is sent when the MRSTP root
switch changes.
zyMstpNewRoot 1.3.6.1.4.1.890.1.15.3.53.3.1 This trap is sent when the MSTP root
switch changes.
STPTopologyChange 1.3.6.1.2.1.17.0.2 This trap is sent when the STP topology
changes.
zyMrstpTopologyChange 1.3.6.1.4.1.890.1.15.3.52.3.2 This trap is sent when the MRSTP topology
changes.
zyMstpTopologyChange 1.3.6.1.4.1.890.1.15.3.53.3.2 This trap is sent when the MSTP root
switch changes.
mactable zyMacForwardingTableFull 1.3.6.1.4.1.890.1.15.3.48.2.1 This trap is sent when more than 99% of
the MAC table is used.
rmon RmonRisingAlarm 1.3.6.1.2.1.16.0.1 This trap is sent when a variable goes over
the RMON "rising" threshold.
RmonFallingAlarm 1.3.6.1.2.1.16.0.2 This trap is sent when the variable falls
below the RMON "falling" threshold.
cfm dot1agCfmFaultAlarm 1.3.111.2.802.1.1.8.0.1 The trap is sent when the Switch detects a
connectivity fault.
classifier zyAclV2ClassifierLogNotifica
tion
1.3.6.1.4.1.890.1.15.3.105.4.1 This trap is sent when the Switch detects
classifier log information.