Chapter 6 Basic Setting
GS3700/XGS3700 Series User’s Guide
92
6.9.11 DHCPv6 Client Setup
Use this screen to configure the Switch’s DHCP settings when it is acting as a DHCPv6 client. Click
the link next to I Pv6 Neighbor Setup in the I Pv6 Configuration screen to display the screen as
shown next.
Figure 54 Basic Setting > IPv6 > IPv6 Configuration > DHCPv6 Client Setup
The following table describes the labels in this screen.
Cancel Click Cancel to begin configuring this screen afresh.
Clear Click Clear to reset the fields to the factory defaults.
Index This is the interface index number. Click on an index number to change the settings.
Interface This is the name of the IPv6 interface you created.
Neighbor Address This field displays the IPv6 address of the neighboring device which can be reached
through the interface
MAC This field displays the MAC address of the neighboring device which can be reached
through the interface.
Select an entry’s check box to select a specific entry. Otherwise, select the check box
in the table heading row to select all entries.
Delete Check the entry(ies) that you want to remove and then click Delete to remove the
selected entry(ies) from the summary table.
Cancel Click Cancel to clear the check boxes.
Table 33 Basic Setting > IPv6 > IPv6 Configuration > IPv6 Neighbor Setup (continued)
LABEL DESCRIPTION
Table 34 Basic Setting > IPv6 > IPv6 Configuration > DHCPv6 Client Setup
LABEL DESCRIPTION
Interface Select the IPv6 interface you want to configure.
IA Type Select I A-NA to set the Switch to get a non-temporary IP address from the DHCPv6
server for this interface.
Optionally, you can also select Rapid-Commit to have the Switch send its DHCPv6
Solicit message with a Rapid Commit option to obtain information from the DHCPv6
server by a rapid two-message exchange. The Switch discards any Reply messages
that do not include a Rapid Commit option. The DHCPv6 server should also support the
Rapid Commit option to have it work well.
To Next Page
Loading...
