Chapter 47 Maintenance
GS3700/XGS3700 Series User’s Guide
448
47.2 Firmware Upgrade
Make sure you have downloaded (and unzipped) the correct model firmware and version to your
computer before uploading to the device.
Be sure to upload the correct model firmware as uploading the wrong
model firmware may damage your device.
The Switch supports dual firmware images, Firmw are 1 and Firmw are 2. Use this screen to
specify which image is updated when firmware is uploaded using the web configurator and to
specify which image is loaded when the Switch starts up.
Click Management > Maintenance > Firm w are Upgrade to view the screen as shown next.
Figure 339 Management > Maintenance > Firmware Upgrade (Standalone mode)
Reboot
System
Click Config 1 to reboot the system and load Configuration 1 on the Switch.
Click Config 2 to reboot the system and load Configuration 2 on the Switch.
Click Stacking Default to reboot the system and load stacking configurations on the Switch.
Click Factory Default to reboot the system and load the factory default configuration on the
Switch.
Note: Make sure to click the Save button in any screen to save your settings to the current
configuration on the Switch.
Tech-Support Click Click Here to see the Tech-Support screen. You can set CPU and memory thresholds
for log reports and download related log reports for issue analysis. Log reports include CPU
history and utilization, crash and memory.
Table 222 Management > Maintenance (continued)
LABEL DESCRIPTION
To Next Page
Loading...
