Chapter 25 IP Source Guard
GS3700/XGS3700 Series User’s Guide
293
25.15 IPv6 Snooping VLAN Setup
Use this screen to enable a DHCPv6 snooping policy on a specific VLAN interface. To open this
screen, click Advanced Application > I P Source Guard > I Pv6 Snooping VLAN Setup.
Figure 204 Advanced Application > IP Source Guard > IPv6 Snooping VLAN Setup (Standalone
mode)
The following table describes the labels in this screen.
Clear Click this to clear the fields above.
Index This field displays a sequential number for each IPv6 snooping policy.
Name This field displays the descriptive name for identification purposes for this IPv6 source
guard policy.
Protocol This field displays the protocols learned from DHCPv6 sniffed packets.
Prefix Glean This field displays the IPv6 prefixes learned from DHCPv6 sniffed packets.
Limit Address
Count
This field displays the the number of IPv6 addresses and prefixes learned using the IPv6
snooping policy.
Delete Select an entry checkbox and click Delete to rem ove the specified entry.
Cancel Click this to clear the Delete check boxes above.
Table 139 Advanced Application > IP Source Guard > IPv6 Snooping Policy Setup (Standalone
mode)
LABEL DESCRIPTION
Table 140 Advanced Application > IP Source Guard > IPv6 Snooping VLAN Setup (Standalone
mode)
LABEL DESCRIPTION
Interface Select the VLAN interface to apply the selected DHCPv6 snooping policy.
Policy Select the IPv6 snooping policy to apply to this VLAN interface.
Add Click this to create the IPv6 source guard policy or to update an existing one.
Cancel Click this to reset the values above or if not applicable, to clear the fields above.
Clear Click this to clear the fields above.
Index This field displays a sequential number for each binding.
Interface This field displays the VLAN interface.
Policy This field displays the DHCPv6 snooping policy.
To Next Page
Loading...
