Chapter 30 PPPoE
GS3700/XGS3700 Series User’s Guide
322
30.3.2 PPPoE IA Per-Port Per-VLAN
Use this screen to configure PPPoE IA settings that apply to a specific VLAN on a port.
Click the VLAN link in the I nterm ediate Agent > Port screen to display the screen as shown.
Figure 231 Advanced Application > PPPoE > Intermediate Agent > Port > VLAN (Standalone mode)
Figure 232 Advanced Application > PPPoE > Intermediate Agent > Port > VLAN (Stacking mode)
Remote-id Enter a string of up to 63 ASCII characters that the Switch adds into the Agent Remote ID
sub-option for PPPoE discovery packets received on this port. Spaces are allowed.
If you do not specify a string here or in the Remote-id field for a VLAN on a port, the Switch
automatically uses the PPPoE client’s MAC address.
The Rem ote I D you configure for a specific VLAN on a port ( in the Advanced Application >
PPPoE > I ntermediate Agent > Port > VLAN screen) has the highest priority.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 154 Advanced Application > PPPoE > Intermediate Agent > Port (continued)
LABEL DESCRIPTION
To Next Page
Loading...
