ZyXEL Communications GS3700 Series - Classifier Example

Chapter 19 Classifier
GS3700/XGS3700 Series User’s Guide
208
19.5 Classifier Example
The following screen shows an example of configuring a classifier that identifies all traffic from MAC
address 00: 50: ba:ad: 4f: 81 on port 2.
Active Select this to allow the Switch to create a log when packets match a classifier rule during a
defined time interval.
Interval Select the length of the time period (in seconds) to count matched packets for a classifier rule.
Enter an integer from 0-65535. 0 means that no logging is done.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 90 Advanced Application > Classifier > Classifier Configuration > Classifier Global Setting
LABEL DESCRIPTION