Chapter 39 ZULD
GS3700/XGS3700 Series User’s Guide
393
39.3 ZULD Configuration
Use this screen to enable ZULD on a port, configure a mode and set the probe time. To open this
screen, click Advanced Application > ZULD > Configuration.
Link State This field shows the following link states:
• Linkdow n: This is an initialization state, where the port is not yet up.
• Probe: This indicates that ZULD is discovering the connected device on this link.
• Bidirectional: Traffic sent by the Switch is received by the connected device on
this link, and traffic from the connected device on this link is received by the
Switch.
• Unidirectional: The state of the link between the port and its connected port
cannot be determined either because no ZULD message was received, or one port
is not capable of sending traffic.
• Shutdow n: The port has been shut down because its link with the connected
device is unidirectional and ZULD is in Aggressive mode.
Remote Operation This field displays whether ZULD is enabled or disabled on the connected device on
this link. ZULD must be enabled on the connected device and on the port that’s
connecting to the Switch.
Remote MAC Addr This is the MAC address of the port on the connected device to which the port of the
Switch is connected.
Remote Port This is the port number of the port on the connected device to which the port of the
Switch is connected.
Table 190 Advanced Application > ZULD Status
LABEL DESCRIPTION
To Next Page
Loading...
