Chapter 23 Multicast
GS3700/XGS3700 Series User’s Guide
235
23.3.3 IGMP Filtering Profile
An IGMP filtering profile specifies a range of multicast groups that clients connected to the Switch
are able to join. A profile contains a range of multicast IP addresses which you want clients to be
able to join. Profiles are assigned to ports (in the I GMP Snooping screen). Clients connected to
those ports are then able to join the multicast groups specified in the profile. Each port can be
assigned a single profile. A profile can be assigned to multiple ports.
Click Advanced Application > Multicast > I Pv4 Multicast in the navigation panel. Click the
I GMP Snooping link and then the I GMP Filtering Profile link to display the screen as shown.
Figure 158 Advanced Application > Multicast > IPv4 Multicast > IGMP Snooping > IGMP Filtering
Profile
Add Click this to create a new entry or to update an existing one.
This saves your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel
to save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to reset the fields to your previous configuration.
Clear Click Clear to reset the fields to the factory defaults.
Index This is the index number of the IGMP snooping VLAN entry in the table.
Name This field displays the descriptive name for this VLAN group.
VID This field displays the ID number of the VLAN group.
Select an entry’s check box to select a specific entry. Otherwise, select the check box in
the table heading row to select all entries.
Delete Check the entry(ies) that you want to remove, then click the Delete button.
Cancel Click Cancel to clear the check boxes.
Table 102 Advanced Application > Multicast > IPv4 Multicast > IGMP Snooping > IGMP Snooping
VLAN (continued)
LABEL DESCRIPTION
To Next Page
Loading...
