Chapter 44 VRRP
GS3700/XGS3700 Series User’s Guide
434
The following table describes the labels in this screen.
44.3.4 Viewing VRRP Summary
View the VRRP configuration summary at the bottom of the screen.
Figure 323 IP Application > VRRP Configuration: Summary
The following table describes the labels in this screen.
Table 217 IP Application > VRRP Configuration: VRRP Parameters
LABEL DESCRIPTION
Active Select this option to enable this VRRP entry.
Name Enter a descriptive name (up to 32 printable ASCII characters) for identification
purposes.
Network Select an IP domain to which this VRRP entry applies.
Virtual Router ID Select a virtual router number (1 to 7) for which this VRRP entry is created.
You can configure up to seven virtual routers for one network.
Advertisement
Interval
Specify the num ber of seconds between Hello message transmissions. The default is
1.
Preempt Mode Select this option to activate preempt mode.
Priority Enter a number (between 1 and 254) to set the priority level. The bigger the number,
the higher the priority.
This field is 100 by default.
Uplink Gateway Enter the I P address of the uplink gateway in dotted decimal notation.
The Switch checks the link to the uplink gateway.
Response Ping Select this option to have the Switch respond to a ping that is sent to the virtual IP
address.
Primary Virtual IP Enter the IP address of the primary virtual router in dotted decimal notation.
Secondary Virtual IP This field is optional. Enter the IP address of a secondary virtual router in dotted
decimal notation. This field is ignored when you enter 0.0.0.0 .
Add Click this to create a new entry or to update an existing one.
This saves your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are done
configuring.
Cancel Click Cancel to discard all changes made in this table.
Clear Click Clear to set the above fields back to the factory defaults.
Table 218 IP Application > VRRP Configuration: Summary
LABEL DESCRIPTION
Index This field displays the index number of an entry. Click an index number to change the
settings.
Active This field shows whether a VRRP entry is enabled (Yes) or disabled (No).
To Next Page
Loading...
