Chapter 6 Basic Setting
GS3700/XGS3700 Series User’s Guide
79
Note: The total power available varies by Switch. Use the show pwr command to see the
total power available for your Switch. The number of ports that can be powered by
PoE is the (total power available) / (maximum power available per port).
In Consum ption mode the power available per port is from 1 to 33 watts.
Configure the maximum power available per port in the Max Pow er ( mW ) field in
Basic Setting > PoE Status > PoE Setup.
In Classification mode the power available per port is from 1 to 30 watts. The
maximum power available per port depends on the the power classification of the
connected PD - see the Class field in Basic Setting > PoE Status > PoE Setup.
6.8 Interface Setup
An IPv6 address is configured on a per-interface basis. The interface can be a physical interface (for
example, an Ethernet port) or a virtual interface (for example, a VLAN). The Switch supports the
VLAN interface type for IPv6 at the time of writing.
Use this screen to set IPv6 interfaces on which you can configure an IPv6 address to access and
manage the Switch. Click Basic Setting > I nterface Setup in the navigation panel to display the
configuration screen.
Figure 42 Basic Setting > Interface Setup
The following table describes the labels in this screen.
Table 22 Basic Setting > Interface Setup
LABEL DESCRIPTION
Interface Type Select the type of I Pv6 interface for which you want to configure. The Switch supports the
VLAN interface type for IPv6 at the time of writing.
Interface ID Specify a unique identification number (from 1 to 4094) for the interface.
Note: To have IPv6 function properly, you should configure a static VLAN with the same ID
number in the Advanced Setup > VLAN screens.
Add Click this to create a new entry.
This saves your changes to the Switch’s run-time memory. The Switch loses these changes
if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to reset the fields to your previous configuration.
To Next Page
Loading...
