ZyXEL Communications GS3700 Series - LLDP Configuration Basic Org-Specific TLV Setting

Chapter 35 Link Layer Discovery Protocol (LLDP)
GS3700/XGS3700 Series User’s Guide
362
Figure 263 Advanced Application > LLDP > LLDP Configuration> Basic TLV Setting (Stacking mode)
The following table describes the labels in this screen.
35.6.2 LLDP Configuration Basic Org-specific TLV Setting
Use this screen to configure organization-specific TLV settings. Click Advanced Application >
LLDP > LLDP Configuration > Org-specific TLV Setting to display the screen as shown next.
Table 175 Advanced Application > LLDP > LLDP Configuration > Basic TLV Setting
LABEL DESCRIPTION
Slot (Stacking
mode)
This field appears only in stacking mode. Click the drop-down list to choose the slot
number of the Switch in a stack.
Port This displays the Switch’s port number.
Management
Address
Select the check box(es) to enable or disable the sending of Management Address TLVs
on the port(s).
Port Description Select the check box(es) to enable or disable the sending of Port Description TLVs on the
port(s).
System
Capabilities
Select the check box(es) to enable or disable the sending of System Capabilities TLVs on
the port(s).
System
Description
Select the check box(es) to enable or disable the sending of System Description TLVs on
the port(s).
System Name Select the check box(es) to enable or disable the sending of System Name TLVs on the
port(s).
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.