Chapter 3 Hardware Overview
GS3700/XGS3700 Series User’s Guide
33
Figure 9 Installed Transceiver
3.1.2.2 Transceiver Removal
Use the following steps to remove a transceiver.
1 Open the transceiver’s latch (latch styles vary).
Figure 10 Opening the Transceiver’s Latch Example
2 Pull the transceiver out of the slot.
Figure 11 Transceiver Removal Example
3.1.3 Management Port
The 100Base-T Ethernet MGMT (management) port is used for local management. Connect directly
to this port using an Ethernet cable. You can configure the Switch via Telnet or the web
configurator.
The default IP address of the management port is 192.168.0.1 with a subnet mask of
255.255.255.0.
3.1.4 Console Port
For local management, you can use a computer with terminal emulation software configured to the
following parameters:
• VT100 terminal emulation
• 9600 bps
To Next Page
Loading...
