Chapter 4 The Web Configurator
GS3700/XGS3700 Series User’s Guide
42
4.3.1 Change Your Password
After you log in for the first time, it is recommended you change the default administrator
password. Click Managem ent > Access Control > Logins to display the next screen.
DiffServ This link takes you to screens where you can enable DiffServ, configure marking rules and
set DSCP-to-IEEE802.1p mappings.
DHCP This link takes you to screens where you can configure the DHCP settings.
VRRP This link takes you to screens where you can configure redundant virtual router for your
network.
Load Sharing This link takes you to a screen where you can enable Equal-Cost MultiPath (ECMP) routing
and set the criteria the Switch uses to determine the routing path for a packet.
ARP Setup This link takes you to a screen where you can configure ARP learning mode on a per-port
basis and create static ARP entries which do not age out.
Management
Maintenance This link takes you to screens where you can perform firmware and configuration file
maintenance as well as reboot the system.
Access Control This link takes you to screens where you can change the system login password and
configure SNMP and remote management.
Diagnostic This link takes you to screens where you can ping IP addresses, run traceroute, test
port(s).
System Log This link takes you to a screen where you can view system logs.
Syslog Setup This link takes you to a screen where you can setup system logs and a system log server.
Cluster
Management
This link takes you to a screen where you can configure clustering management and view
its status.
MAC Table This link takes you to a screen where you can view the MAC address and VLAN ID of a
device attach to a port. You can also view what kind of MAC address it is.
IP Table This link takes you to a screen where you can view the IP addresses and VLAN ID of a
device attached to a port.You can also view what kind of device it is.
ARP Table This link takes you to a screen where you can view the MAC address – IP address
resolution table.
Routing Table This link takes you to a screen where you can view the routing table.
Path MTU Table This link takes you to a screen where you can view the IPv6 path MTU table.
Configure Clone This link takes you to a screen where you can copy attributes of one port to (an)other
port(s).
IPv6 Neighbor
Ta b l e
This link takes you to a screen where you can view the Switch’s IPv6 neighbor table.
Port Status This link takes you to a screen where you can view the port statistics.
Table 5 Navigation Panel Links (continued)
LINK DESCRIPTION
To Next Page
Loading...
