ZyXEL Communications GS3700 Series - OAM Remote Loopback

Chapter 38 OAM
GS3700/XGS3700 Series User’s Guide
389
38.4 OAM Remote Loopback
Use this screen to perform a remote-loopback test. In the OAM Status screen click Rem ote
Loopback to display the screen as shown.
Figure 283 Advanced Application > OAM > OAM Remote Loopback
The following table describes the fields in the above screen.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 188 Advanced Application > OAM > OAM Configuration
LABEL DESCRIPTION
Table 189 Advanced Application > OAM > OAM Remote Loopback
LABEL DESCRIPTION
Remote Loopback
Te st
Port Enter the number of the port from which the Switch performs a remote-loopback test.
Number of
Packet
Define the allowable packet number of the loopback test frames.
Packet Size Define the allowable packet size of the loopback test frames.
Te st Cl i c k Test to begin the test.
Remote Loopback
Mode
Port Enter the number of the port from which the Switch sends loopback control PDUs to
initiate or terminate a remote-loopack test.
Start Click Start to initiate a remote-loopback test from the specified port by sending Enable
Loopback Control PDUs to the rem ote device.
Stop Click Stop to terminate a remote-loopback test from the specified port by sending
Disable Loopback Control PDUs to the remote device.