Chapter 14 Mirroring
GS3700/XGS3700 Series User’s Guide
170
14.1.4 Destination
Use this screen to specify the RMirror VLAN and configure the monitor port when the Switch is the
destination device in remote port mirroring.
Click the Destination link in the RMirror screen. The following screen opens.
Figure 114 Advanced Application > Mirroring > RMirror > Destination
* Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this
row first to set the common settings and then make adjustments on a port-by-port
basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Mirrored Select this option to mirror the traffic on a port.
Direction Specify the direction of the traffic to mirror by selecting from the drop-down list box.
Choices are Egress (outgoing), I ngress (incoming) and Both.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the nonvolatile memory when you are done
configuring.
Cancel Click Cancel to begin configuring this screen afresh.
VLAN This field displays the ID number of RMirror VLAN over which the mirrored traffic is
forwarded.
Priority This field displays the priority of the mirrored traffic.
Mirror Port
Ingress This field displays the number of port(s) on which the incoming traffic is mirrored.
Egress This field displays the number of port(s) on which the outgoing traffic is mirrored.
Both This field displays the number of port(s) on which the incoming and outgoing traffic is
mirrored.
Reflector Port This field displays whether the reflector port is enabled and the number of reflector
port in this RMirror VLAN.
Table 71 Advanced Application > Mirroring > RMirror > Source (continued)
LABEL DESCRIPTION
To Next Page
Loading...
