ZyXEL Communications GS3700 Series - Ipv6 Router Discovery Setup

Chapter 6 Basic Setting
GS3700/XGS3700 Series User’s Guide
88
6.9.8 IPv6 Router Discovery Setup
Use this screen to configure router discovery settings for each interface. Click the link next to I Pv6
Router Discovery Setup in the I Pv6 Configuration screen to display the screen as shown next.
Figure 51 Basic Setting > IPv6 > IPv6 Configuration > IPv6 Router Discovery Setup
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the nonvolatile memory when you are done
configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Clear Click Clear to reset the fields to the factory defaults.
Index This is the interface index number. Click on an index number to change the settings.
Interface This is the name of the IPv6 interface you created.
DAD Attempts This field displays the number of consecutive neighbor solicitations the Switch sends
for this interface.
NS Interval This field displays the time interval (in milliseconds) at which neighbor solicitations are
re-sent for this interface.
Reachable Time This field displays how long (in milliseconds) a neighbor is considered reachable for
this interface.
Table 30 Basic Setting > IPv6 > IPv6 Configuration > IPv6 Neighbor Discovery Setup (continued)
LABEL DESCRIPTION