ZyXEL Communications GS3700 Series - MLD Snooping-proxy; MLD Snooping-proxy VLAN

Chapter 23 Multicast
GS3700/XGS3700 Series User’s Guide
237
The following table describes the labels in this screen.
23.4.1 MLD Snooping-proxy
Click the MLD Snooping-proxy link in the Advanced Application > Multicast > I Pv6 Multicast
screen to display the screen as shown. See
Section 23.1 on page 227 for more information on
multicasting.
Figure 160 Advanced Application > Multicast > IPv6 Multicast > MLD Snooping-proxy
The following table describes the labels in this screen.
23.4.2 MLD Snooping-proxy VLAN
Click the MLD Snooping-proxy link and then the VLAN link in the Advanced Application >
Multicast > I Pv6 Multicast screen to display the screen as shown. See
Section 23.1 on page 227
for more information on multicasting.
Table 104 Advanced Application > Multicast > IPv6 Multicast
LABEL DESCRIPTION
Index This is the index number of the entry.
VID This field displays the multicast VLAN ID.
Port This field displays the port number that belongs to the multicast group. In stacking
mode, the first number represents the slot and the second the port number.
Multicast Group This field displays IP multicast group addresses.
Group Timeout This field displays the time (in seconds) that elapses before the Switch removes an MLD
group membership entry if it does not receive report messages from the port.
Table 105 Advanced Application > Multicast > IPv6 Multicast > MLD Snooping-proxy
LABEL DESCRIPTION
MLD Snooping-
proxy
Use these settings to configure MLD snooping-proxy.
Active Select Active to enable MLD snooping-proxy on the Switch to minimize MLD control
messages and allow better network performance.
802.1p Priority Select a priority level (0-7) to which the Switch changes the priority in outgoing MLD
messages.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.