Chapter 38 OAM
GS3700/XGS3700 Series User’s Guide
388
Figure 282 Advanced Application > OAM > OAM Configuration (Stacking mode)
The following table describes the fields in the above screen.
Table 188 Advanced Application > OAM > OAM Configuration
LABEL DESCRIPTION
Active Select this option to enable Ethernet OAM on the Switch.
Slot (Stacking mode) This field appears only in stacking mode. Click the drop-down list to choose the slot
number of the Switch in a stack.
Port This field displays the Switch’s port number. In stacking m ode, the first box field is the
slot I D and the second field is the port number. * means all ports (on the same
Switch).
* Use this row to make the setting the same for all ports. Use this row first and then
make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Active Select this check box to enable Ethernet OAM on this port.
Clear this check box to disable Ethernet OAM on the port.
Mode Specify the OAM mode on the port.
Select Active to allow the port to issue and respond to Ethernet OAM commands.
Select Passive to allow the port to respond to Ethernet OAM commands.
Remote Loopback
Supported
Select this check box to enable the remote loopback feature on the port. Otherwise,
clear the check box to disable it.
Remote Loopback
Ignore-Rx
Select this check box to set the Switch to process loopback commands received on the
port. Otherwise, clear the check box to have the Switch ignore loopback commands
received on the port.
To Next Page
Loading...
