Chapter 12 Bandwidth Control
GS3700/XGS3700 Series User’s Guide
159
Port
(Standalone or
stacking
mode)
This field displays the port number. In stacking mode, the first box field is the slot ID and the
second field is the port number.
* Settings in this row apply to all ports.
Use this row only if you want to m ake some settings the same for all ports. Use this row first
to set the common settings and then m ake adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Ingress Rate
Active Select this check box to activate commit rate limits on this port.
Commit
Rate
Specify the guaranteed bandwidth allowed in kilobits per second (Kbps) for the incoming
traffic flow on a port. The commit rate should be less than the peak rate. The sum of commit
rates cannot be greater than or equal to the uplink bandwidth.
Active Select this check box to activate peak rate limits on this port.
Peak Rate Specify the maximum bandwidth allowed in kilobits per second (Kbps) for the incoming
traffic flow on a port.
Active Select this check box to activate egress rate limits on this port.
Egress Rate Specify the maximum bandwidth allowed in kilobits per second (Kbps) for the out-going
traffic flow on a port.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 65 Advanced Application > Bandwidth Control (continued)
LABEL DESCRIPTION
To Next Page
Loading...
