Chapter 15 Link Aggregation
GS3700/XGS3700 Series User’s Guide
182
Figure 121 Advanced Application > Link Aggregation > Link Aggregation Setting > LACP (Stacking
mode)
The following table describes the labels in this screen.
Table 78 Advanced Application > Link Aggregation > Link Aggregation Setting > LACP
LABEL DESCRIPTION
Link
Aggregation
Control
Protocol
Note: Do not configure this screen unless you want to enable dynamic link aggregation.
Active Select this checkbox to enable Link Aggregation Control Protocol (LACP).
System Priority LACP system priority is a number between 1 and 65,535. The switch with the lowest system
priority (and lowest port number if system priority is the sam e) becomes the LACP “server”.
The LACP “ ser ver” cont rols the operat ion of LACP set up. Ent er a num ber to set the priorit y of
an active port using Link Aggregation Control Protocol (LACP). The smaller the number, the
higher the priority level.
Group ID The field identifies the link aggregation group, that is, one logical link containing multiple
ports.
LACP Active Select this option to enable LACP for a trunk.
To Next Page
Loading...
