Chapter 21 Queuing Method
GS3700/XGS3700 Series User’s Guide
218
Hybrid-
SPQ
Lowest-
Queue
This field is applicable only when you select W FQ or W RR.
Select a queue (Q0 to Q7) to have the Switch use SPQ to service the subsequent queue(s) after
and including the specified queue for the 1000Base-T, 1000Base-X and 10 Gigabit Ethernet
ports. For example, if you select Q5 , the Switch services traffic on Q5, Q6 and Q7 using SPQ.
Select None to always use W FQ or W RR.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 92 Advanced Application > Queuing Method (continued)
LABEL DESCRIPTION
To Next Page
Loading...
