ZyXEL Communications GS3700 Series - Page 315

Chapter 29 sFlow
GS3700/XGS3700 Series User’s Guide
315
Figure 226 Advanced Application > sFlow > Collector
The following table describes the labels in this screen.
Table 147 Advanced Application > sFlow > Collector
LABEL DESCRIPTION
Collector
Address
Enter the IP address of the sFlow collector.
UDP Port Enter a UDP port number the Switch uses to send sFlow datagram to the collector. If you
change the port here, make sure you change it on the collector, too. The default port is
6343.
Add Click this to create a new entry or to update an existing one.
This saves your changes to the Switch’s run-time memory. The Switch loses these changes
if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to reset the fields to your previous configuration.
Clear Click Clear to reset the fields to the factory defaults.
Index This field displays the index number of this entry. Click on an index number to change the
settings.
Collector
Address
This field displays IP address of the sFlow collector.
UDP Port This field displays port number the Switch uses to send sFlow datagram to the collector.
Delete Check the rule(s) that you want to remove in the Delete column and then click the Delete
button.
Cancel Click Cancel to begin configuring this screen afresh.