Chapter 31 Error Disable
GS3700/XGS3700 Series User’s Guide
332
Figure 241 Advanced Application > Errdisable > Errdisable Recovery (Stacking Mode)
The following table describes the labels in this screen.
Table 161 Advanced Application > Errdisable > Errdisable Recovery
LABEL DESCRIPTION
Active Select this option to turn on the error-disable recovery function on the Switch.
Reason This field displays the supported features that allow the Switch to shut down a port or
discard packets on a port according to the feature requirements and what action you
configure.
* Use this row to make the setting the same for all entries. Use this row first and then make
adjustments to each entry if necessary.
Note: Changes in this row are copied to all the entries as soon as you make them.
Timer Status Select this option to allow the Switch to wait for the specified time interval to activate a port
or allow specific packets on a port, after the error was gone. Deselect this option to turn off
this rule.
Interval Enter the number of seconds (from 30 to 2592000) for the time interval.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
To Next Page
Loading...
