Chapter 32 MAC Pinning
GS3700/XGS3700 Series User’s Guide
335
The following table describes the labels in this screen.
Table 162 Advanced Application > MAC Pinning
LABEL DESCRIPTION
Active Select this option to turn on the MAC pinning function on the Switch.
Slot (Stacking
mode)
This field appears only in stacking mode. Click the drop-down list to choose the slot number
of the Switch in a stack.
Port
(Standalone or
stacking mode)
This field displays the port number. In stacking mode, the first field is the slot ID and the
second field is the port number. * means all ports (on the same Switch).
* Use this row to make the setting the same for all ports. Use this row first and then make
adjustments to each port if necessary.
Note: Changes in this row are copied to all the ports as soon as you make them.
Active Select this check box to enable MAC pinning on this port. The port then has priority over
other ports in MAC address learning.
Clear this check box to disable MAC pinning.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
To Next Page
Loading...
