Chapter 6 Basic Setting
GS3700/XGS3700 Series User’s Guide
58
Figure 25 Basic Setting > System Info (Stacking Mode)
The following table describes the labels in these screens.
Table 10 Basic Setting > System Info (Standalone and Stacking Modes)
LABEL DESCRIPTION
System Name This field displays the descriptive name of the Switch for identification purposes.
Product Model This field displays the product model of the Switch. Use this information when searching for
firmware upgrade or looking for other support information in the website.
ZyNOS F/ W
Version
This field displays the version number of the Switch 's current firmware including the date
created.
Ethernet
Address
This field refers to the Ethernet MAC (Media Access Control) address of the Switch.
CPU Utilization CPU utilization quantifies how busy the system is. Current ( % ) displays the current
percentage of CPU utilization.
Memory
Utilization
Memory Utilization shows how much DRAM memory is available and in use. It also displays
the current percentage of memory utilization.
Name This field displays the name of memory pool.
Total This field displays the total number of bytes in this memory pool.
Used This field displays the number of bytes being used in this memory pool.
Utilization This field displays the percentage (% ) of memory being used in this memory pool.
Hardware Monitor (Standalone Mode)
Temperature
Unit
The Switch has temperature sensors that are capable of detecting and reporting if the
temperature rises above the threshold. You may choose the temperature unit (Centigrade or
Fahrenheit) in this field.
Te m p e r a t u r e BOARD, MAC and PHY refer to the location of the temperature sensors on the Switch
printed circuit board.
Current This shows the current temperature at this sensor.
MAX This field displays the maximum temperature measured at this sensor.
To Next Page
Loading...
