Chapter 6 Basic Setting
GS3700/XGS3700 Series User’s Guide
71
Figure 35 Basic Setting > Port Setup (XGS3700 Series: Stacking mode)
The following table describes the labels in this screen.
Table 18 Basic Setting > Port Setup
LABEL DESCRIPTION
Slot (Stacking
mode)
This field appears only in stacking mode. Click the drop-down list to choose the slot number
of the Switch in a stack.
Port This is the port index number. In stacking mode, the first number is the slot ID and the
second is the port number. * means all ports.
* Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row
first to set the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Active Select this check box to enable a port. The factory default for all ports is enabled. A port
must be enabled for data transmission to occur.
Name Type a descriptive name that identifies this port. You can enter up to 64 alpha-numerical
characters.
Note: Due to space limitations, the port name may be truncated in some web configurator
screens.
Type This field displays 10 M / 100M/ 1000M for a 1000Base-T connection, 100 0 M for a
1000Base-X connection, and 10G for a 10 Gigabit connection (available only on the Switch
that has a 10 Gigabit interface).
To Next Page
Loading...
