Chapter 6 Basic Setting
GS3700/XGS3700 Series User’s Guide
74
Figure 38 Basic Setting > PoE Setup (Stacking mode)
The following table describes the labels in this screen.
Table 19 Basic Setting > PoE Setup
LABEL DESCRIPTION
PoE Status
PoE Mode This field displays the power management mode used by the Switch, whether it is in
Classification or Consumption mode.
Total Power (W) This field displays the total power the Switch can provide to the connected PoE-enabled
devices on the PoE ports.
Consuming Power
(W)
This field displays the total amount of power the Switch is currently supplying to the
connected PoE-enabled devices.
Allocated Power (W) This field displays the total amount of power the Switch has reserved for PoE after
negotiating with the connected PoE device(s).
Consuming Pow er ( W ) can be less than or equal but not more than the Allocated
Pow er ( W ) .
Rem aining Power
(W)
This field displays the amount of power the Switch can still provide for PoE.
Note: The Switch must have at least 16 W of remaining power in order to supply power
to a PoE device, even if the PoE device needs less than 16 W.
Port (Standalone
and stacking mode)
This is the port index number.
State This field shows which ports can receive power from the Switch. You can set this in the
Basic Setting > PoE Setup screen.
• Disable - The PD connected to this port cannot get power.
• Enable - The PD connected to this port can receive power.
To Next Page
Loading...
