Chapter 6 Basic Setting
GS3700/XGS3700 Series User’s Guide
77
Figure 41 Basic Setting > PoE Setup > PoE Setup (Stacking mode)
The following table describes the labels in this screen.
Table 21 Basic Setting > PoE Setup > PoE Setup
LABEL DESCRIPTION
PoE Mode Select the power management mode you want the Switch to use.
• Classification - Select this if you want the Switch to reserve the Max Power (mW)
to each PD according to the power classification of the PD. If the total power supply
available is not enough to supply all connected PDs, then PDs with lower priority do
not get power to function.
• Consumption - Select this if you want the Switch to manage the total power
supply so that each connected PD gets a resource. However, the power allocated by
the Switch may be less than the Max Pow er ( m W ) of the PD. PDs with higher
priority also get more power than those with lower priority levels.
Slot (Stacking mode) This field appears only in stacking mode. Click the drop-down list to choose the slot
number of the Switch in a stack.
Port (Standalone or
Stacking mode)
This is the port index number. In stacking mode, the first box field is the slot ID and
the second field is the port number. * means all ports (on the same Switch).
PD Select this to provide power to a PD connected to the port.
If left unchecked, the PD connected to the port cannot receive power from the Switch.
To Next Page
Loading...
