Chapter 6 Basic Setting
GS3700/XGS3700 Series User’s Guide
98
2 After reboot completes, the master LED will turn on.
3 Configure the Switch stacking priority to a high value, such as 63.
4 Change a second Switch to stacking mode and wait for it to finish rebooting automatically. This
master LED will also turn on.
5 Connect the two Switches using the stacking ports for the Switch defined.
6 The second Switch master LED will then turn off, and its Sys LED will blink while it's initializing.
Please wait until it stops blinking, indicating that it has joined the stack.
7 Repeat steps 4 to 6 to connect other Switches to the stack.
When the Switch is in Stacking mode, the web configurator will change port and VLAN port settings
to support the stacking mode. See
Section 6.6 on page 69 and Section 7.7 on page 106 for details
on the port settings.
Click Basic Setting > Stacking > Configuration to see the following screen.
Figure 59 Basic Setting > Stacking > Configuration
To Next Page
Loading...
