Chapter 9 VLAN
XGS4600 Series User’s Guide
136
Figure 109 Advanced Application > VLAN > VLAN Configuration > Protocol Based VLAN Setup
(Standalone Mode)
Figure 110 Advanced Application > VLAN > VLAN Configuration > Protocol Based VLAN Setup
(Stacking Mode)
The following table describes the labels in this screen.
Table 49 Advanced Application > VLAN > VLAN Configuration > Protocol Based VLAN Setup
LABEL DESCRIPTION
Active Check this box to activate this protocol based VLAN.
Port Type a port number to be included in this protocol based VLAN. In stacking mode, the first
box field is the slot ID and the second field is the port number.
This port must belong to a static VLAN in order to participate in a protocol based VLAN.
Name Enter up to 32 alpha numeric characters to identify this protocol based VLAN.
Ethernet-type Use the drop down list box to select a predefined protocol to be included in this protocol
based VLAN or select Others and type the protocol number in hexadecimal notation. For
example the IP protocol in hexadecimal notation is 0800, and Novell IPX protocol is 8137.
Note: Protocols in the hexadecimal number range of 0x0000 to 0x05ff are not
allowed to be used for protocol based VLANs.
VID Enter the ID of a VLAN to which the port belongs. This must be an existing VLAN which you
defined in the Advanced Application > VLAN > Static VLAN screen.
Priority Select the priority level that the Switch will assign to frames belonging to this VLAN.
To Next Page
Loading...
