Chapter 13 Spanning Tree Protocol
XGS4600 Series User’s Guide
165
Figure 133 Advanced Application > Spanning Tree Protocol > MSTP (Stacking Mode)
The following table describes the labels in this screen.
Table 62 Advanced Application > Spanning Tree Protocol > MSTP
LABEL DESCRIPTION
Status Click Status to display the MSTP Status screen.
Port Click Port to display the MSTP Port screen.
Active Select this check box to activate MSTP on the Switch. Clear this check box to disable MSTP on
the Switch.
Note: You must also activate Multiple Spanning Tree in the Advanced Application >
Spanning Tree Protocol > Configuration screen to enable MSTP on the Switch.
Hello Time This is the time interval in seconds between BPDU (Bridge Protocol Data Units) configuration
message generations by the root switch. The allowed range is 1 to 10 seconds.
To Next Page
Loading...
