Chapter 16 Mirroring
XGS4600 Series User’s Guide
196
Figure 158 Advanced Application > Mirroring > RMirror > Connected Port (Stacking Mode)
The following table describes the labels in this screen.
Table 73 Advanced Application > Mirroring > RMirror > Connected Port
LABEL DESCRIPTION
RMirror VLAN ID Select the RMirror VLAN over which the mirrored traffic is forwarded.
SLOT This field appears only in stacking mode. Click the drop-down list to choose the slot
number of the Switch in a stack.
Port This field displays the port number. In stacking mode, the first number represents the slot ID
and the second is the port number. Please note that the default stacking ports (the last
two ports of your Switch) cannot be configured. They are reserved for stacking only.
* Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to
set the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Connected Port When the Switch is a source device in remote port mirroring, select this option to have the
port help forward mirrored traffic to the connected port of the intermediate or destination
device in the same RMirror VLAN.
When the Switch is an intermediate device in remote port mirroring, select this option to
have the port receive mirrored traffic from the connected source or another intermediate
device or forward mirrored traffic to the connected destination or another intermediate
device in the same RMirror VLAN.
When the Switch is a destination device in remote port mirroring, select this option to have
the port receive mirrored traffic from the connected source or intermediate device in the
same RMirror VLAN.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
To Next Page
Loading...
