Chapter 21 Classifier
XGS4600 Series User’s Guide
234
The following table describes the labels in this screen.
Table 87 Advanced Application > Classifier > Classifier Configuration
LABEL DESCRIPTION
Active Select this option to enable this rule.
Name Enter a descriptive name for this rule for identifying purposes.
Weight Enter a number between 0 and 65535 to specify the rule’s weight. When the match order is in manual
mode in the Classifier Global Setting screen, a higher weight means a higher priority.
Log Select this option to have the Switch create a log message when the rule is applied and record the
number of matched packets in a particular time interval.
Note: Make sure you also enable logging in the Classifier Global Setting screen.
Count Select this option to have the Switch count how many times the rule is applied.
Time
Range
Select the name of the pre-configured schedule that you want to apply to the rule. The rule will be
active only at the scheduled date and/or time.
If you select None, the rule will be active all the time.
Ingress Port
Port Type the port number to which the rule should be applied. You may choose one port only or all ports
(Any). Please note that the default stacking ports (the last two ports of your Switch) cannot be
configured. They are reserved for stacking only.
Trunk Select Any to apply the rule to all trunk groups.
To specify a trunk group, select the second choice and type a trunk group ID.
Packet
Format
Specify the format of the packet. Choices are All, 802.3 tagged, 802.3 untagged, Ethernet II tagged
and Ethernet II untagged.
A value of 802.3 indicates that the packets are formatted according to the IEEE 802.3 standards.
A value of Ethernet II indicates that the packets are formatted according to RFC 894, Ethernet II
encapsulation.
Layer 2
Specify the fields below to configure a layer 2 classifier.
VLAN
VLAN Select Any to classify traffic from any VLAN or select the second option and specify the source VLAN
ID in the field provided.
Inner
VLAN
Select Any to classify traffic from any inner VLAN (the customer's VLAN) or select the second option
and specify the source VLAN ID in the field provided.
Priority
Priority Select Any to classify traffic from any priority level or select the second option and specify a priority
level in the field provided.
Inner
Priority
Select Any to classify traffic from any inner priority level or select the second option and specify a
priority level in the field provided.
Ethernet
Type
Select an Ethernet type or select Other and enter the Ethernet type number in hexadecimal value.
Source
To Next Page
Loading...
