Chapter 36 VLAN Isolation
XGS4600 Series User’s Guide
364
Figure 290 Advanced Application > VLAN Isolation
The following table describes the labels in this screen.
Table 163 Advanced Application > VLAN Isolation
LABEL DESCRIPTION
Active Check this box to enable VLAN Isolation in a VLAN.
Name Enter a descriptive name (up to 32 printable ASCII characters) for identification purposes.
VLAN ID Enter a VLAN ID from 1 to 4094. This is the VLAN to which this rule applies.
Promiscuous Ports Enter the number of the ports that can communicate with any ports in the same VLAN.
Other ports belonging to this VLAN will be added to the isolation list and can only send and
receive traffic from the ports you specify here.
Add Click Add to insert the entry in the summary table below and save your changes to the
Switch’s run-time memory. The Switch loses these changes if it is turned off or loses power, so
use the Save link on the top navigation panel to save your changes to the non-volatile
memory when you are done configuring.
Cancel Click Cancel to reset the fields to your previous configuration.
Clear Click Clear to clear the fields to the factory defaults.
Index This is the index number of the rule.
Active This shows whether this rule is activated or not.
Name This is the descriptive name for this rule.
VLAN This is the VLAN to which this rule is applied.
Promiscuous Ports This shows the ports that can communicate with any ports in the same VLAN.
Select an entry’s check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Delete Check the rules that you want to remove and then click the Delete button.
Cancel Click Cancel to clear the check boxes.
To Next Page
Loading...
