Chapter 43 OAM
XGS4600 Series User’s Guide
421
Figure 337 Advanced Application > OAM > OAM Remote Loopback (Stacking Mode)
The following table describes the fields in the above screen.
Table 191 Advanced Application > OAM > OAM Remote Loopback
LABEL DESCRIPTION
Remote Loopback Test
Port Enter the number of the port from which the Switch performs a remote-loopback test.
In stacking mode, the first field is the slot ID and the second field is the port number.
Number of Packet Define the allowable packet number of the loopback test frames.
Packet Size Define the allowable packet size of the loopback test frames.
Test Click Test to begin the test.
Remote Loopback Mode
Port Enter the number of the port from which the Switch sends loopback control PDUs to initiate
or terminate a remote-loopback test.
In stacking mode, the first field is the slot ID and the second field is the port number.
Start Click Start to initiate a remote-loopback test from the specified port by sending Enable
Loopback Control PDUs to the remote device.
Stop Click Stop to terminate a remote-loopback test from the specified port by sending Disable
Loopback Control PDUs to the remote device.
To Next Page
Loading...
