ZyXEL Communications XGS4600 Series - Page 434

Chapter 46 Wol Relay
XGS4600 Series User’s Guide
434
The following table describes the labels in this screen.
Table 196 Advanced Application > Wol Relay
LABEL DESCRIPTION
Wol Relay
UDP Enter a UDP port number that magic packets are sent through.
The most common port for transmission is UDP port 9.
Source VLAN Enter the source VLAN ID where the magic packet originates from.
Destination VLAN Enter the destination VLAN ID where the magic packet will be sent to.
Add Click Add to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Clear Click Clear to reset the fields to the factory defaults.
Index This field displays the index number of the rule.
UDP This field displays the UDP port of the rule.
Source VLAN This field displays the source VLAN ID of the rule.
Destination VLAN This field displays the destination VLAN ID of the rule.
Select an entry’s check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Delete Click Delete to remove the selected entry from the summary table.
Cancel Click Cancel to clear the check boxes.