ZyXEL Communications XGS4600 Series - Page 441

Chapter 48 Policy Routing
XGS4600 Series User’s Guide
441
Figure 352 IP Application > Policy Routing > Rule Configuration
The following table describes the labels in this screen.
Table 200 IP Application > Policy Routing > Rule Configuration
LABEL DESCRIPTION
Profile Name This field displays the policy routing profiles you configure in the IP Application > Policy Routing
screen.
Select a profile for which you want to configure a policy routing rule.
Sequence Enter the rule number from 1 to 64. The ordering of your rules is important as rules are applied in
turn.
You can not specify a number already in use by another rule.
Statement Select Permit to forward traffic that matches this rule to the gateway specified in the rule.
Select Deny to disable the rule action and forward traffic that matches this rule according to
the routing table on the Switch.
Classifier This field displays the available active classifiers you configure in the Classifier screen, which are
not used by any policy rule or policy routing rule.
Select a classifier to which this policy routing rule applies.
Action Enter the IP address of the gateway. The gateway is an immediate neighbor of your Switch that
will forward the packet to the destination.
Add Click this to create a new entry or to update an existing one.
This saves your changes to the Switch’s run-time memory. The Switch loses these changes if it is
turned off or loses power, so use the Save link on the top navigation panel to save your
changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to reset the fields to your previous configuration.
Clear Click Clear to set the above fields back to the factory defaults.
Active This field displays whether the policy route profile is enabled or not.
Profile Name This field displays the name of the policy route profile with which the rule is associated.
Seq This field displays the rule index number that you configure in the Sequence field. Click an index
number to change the rule’s Statement.
State This field displays permit when the rule action is activated and deny when is it deactivated.