ABB ACF5000 User Manual

ACF5000 FTIR ANALYZER SYSTEM | OI/ACF5000-EN REV. A 185
No. Text S A
W
F Reaction/Comment
512 Automatic adjustment in pro-
gress.
x for information; not in the logbook
513 System bus communication
disrupted during automatic
adjustment.
514 External adjustment started. for information
515 External adjustment ended. for information
516 External adjustment in pro-
gress.
x for information; not in the logbook
517 Device is being serviced. x for information, e.g. during a manual adjustment; not in
the logbook
518 The adjustment could not be
carried out, because the meas-
ured value is instable.
519 Pre-amplifier overrun error: The
adjustment could not be car-
ried out, because the
pre-amplifier is overdriven.
520 Basic adjustment zero point
started.
for information
521 Basic adjustment zero point
ended.
for information
522 Basic adjustment zero point
canceled.
for information
523 Basic adjustment zero point
incomplete. System bus com-
munication disrupted during
adjustment.
for information
524 Basic adjustment zero point in
progress.
x for information; not in the logbook
525 Linearization not possible: The
linearization provides no valid
result. Measured value may be
imprecise. Check center point
gas.
see message text
526 Linearization not possible: The
linearization could not be car-
ried out, as the identification
line is not linear.
see message text
527 Basic adjustment for compo-
nent:
for information
528 Automatic adjustment could
not be started, as the adjust-
ment was manual.
for information
529 The adjustment was canceled,
as no raw measured values can
be entered.
x x
530 The adjustment was canceled,
as the pressure switch did not
detect adjustment gas.
x x
531 Auto validation started. for information
532 Auto validation ended. for information

ABB ACF5000 Specifications

General

Brand	ABB
Model	ACF5000
Category	Measuring Instruments
Language	English