6. Slide the cable through the hole in the cable entry and attach the grommet to
the hole.
IP66 (UL Type 4X) drives: Tighten the cable gland nut on the outside.
WARNING!
If you install IP66 (UL Type 4X) drive indoors or outdoors in a wet, dirty,
dusty, corrosive or similar environment, all cables, conduits and fittings
must be approved for use in this type of environment. Tighten the fittings
properly to the drive to prevent leakage. If you ignore these instructions,
injury or death, or damage to the equipment can occur.
142 Electrical installation – Global (IEC)
To Next Page
Loading...
