1. Select Enabled.
2. For Host/Server, enter the NTRIP Caster address.
3. For Port, enter the NTRIP Caster port numbe. This is usually 2101.
4. Click Save.
5. Click Get Mountpoints.
6. Select your mountpoint from the Mountpoint drop down list, being mindful that the distance should not
exceed 50km.
7. Enter your username in the Username box.
8. Enter your password in the Password box.
9. Click Save.
To disconnect from the NTRIP Caster unselect Enabled and click Save.
Troubleshooting NTRIP Caster Connections
Some mountpoints require that Boreas send its position. To do this, click the Report Position check box, and
then click Save Changes. The current Boreas position will then be sent to the NTRIP Caster every 10 seconds.
If you cannot get the list of mountpoints, ensure the Host Address and Port number are correct for your NTRIP
Caster.
If the Connection Status is not green, and says UNAUTHORISED this indicates an incorrect username or
password.
Contact support@advancednavigation.com for further assistance with network DGPS or RTK.
v1.2 Page 66 11 Oct 2022
Boreas Reference Manual • Configuring and Monitoring Boreas
To Next Page
Loading...
