4 Getting Started
To get started with Boreas for the first time, it is recommended that you begin by establishing communications
to the device, either before or after the unit is installed in its final location. These instructions assume the use of
components provided in the 3 Evaluation Kit, or purchased as Advanced Navigation supplied optional 5.4
Accessories.
1. Plug the power supply into the power connector on the breakout cable and then into the wall socket. See
7.6 Power Supply.
2. Plug the IO breakout cable into the IO connector on the Boreas unit. See 6.6 IO Connection.
3. Connect either the MIL-DTL-38999 Series III terminated cable or a standard Ethernet cable from the Eth-
ernet socket on the Boreas unit to your network or switch. See 6.5 Ethernet Connection.
4. If using Windows, download and install the Bonjour ZeroConf networking utility from the link
https://www.advancednavigation.com/Bonjour64.msi.
5. In a web browser, type the address: http://boreas.local.
There are additional factors that you must review before you proceed with the installation. For more
information, see 7 Installing Boreas.
v1.2 Page 7 11 Oct 2022
Boreas Reference Manual • Getting Started with Boreas
To Next Page
Loading...
