Figure 72: Boreas Manager NTRIP Client Dialogue
Note: These settings refer to the NTRIP Client built into the Boreas Manager application. It is not
possible to configure the NTRIP Client built into Boreas using Boreas Manager. You need to use the
web UI for this.
9.2.8.5 Network Connect
The network connect dialogue allows Boreas Manager to make a connection to Boreas over a TCP/IP network
rather than the primary serial port connection.
Figure 73: Boreas Manager Network Connect Dialogue
9.2.8.6 Serial Passthrough
This function allows pass-through communication through either GPIO 1 and 2 or the Auxiliary port.
Figure 74: Boreas Manager Serial Port Passthrough Dialogue
v1.2 Page 86 11 Oct 2022
Boreas Reference Manual • Configuring and Monitoring Boreas
To Next Page
Loading...
