ADVANTEST R3162 User Manual

R3132 Series Spectrum Analyzer Operation Manual
2.4.3 Outputting Screen Data
2-115
2.4.3 Outputting Screen Data
You can save screen data to a floppy disk, or print it out when needed. When outputting screen data, you
can use any key except the COPY key. You can resume using this key after the data has been output.
(1) Saving to a Floppy Disk
Screen data is saved in BMP (bitmap file) format.
Inserting a floppy disk
1. Insert a floppy disk into the floppy drive.
Selecting the destination
2. Press CONFIG, Copy Config and Copy Device PRT/FD(FD).
The FD is selected as the destination of the screen data.
Figure 2-116 Screen Display Showing Floppy Disk as the Specified Destination
3. Press COPY after displaying the screen data to be saved. The access lamp
remains lit while the screen data is being saved to disk, and goes out when the file
has been saved.
CAUTION: Do not remove the floppy disk while the access lamp is lit, since the
floppy disk is being accessed. If you remove the disk while the disk is
being accessed, you may damage the data on the disk.

ADVANTEST R3162 Specifications

General

Brand	ADVANTEST
Model	R3162
Category	Measuring Instruments
Language	English