R3132 Series Spectrum Analyzer Operation Manual
3.3.24 SINGLE Key (Single Sweep)
3-72
3.3.24 SINGLE Key (Single Sweep)
If this key is pressed during a sweep, the sweep is paused and the sweep lamp is turned off. Pressing the
SINGLE
key again causes the analyzer to wait until a sweep starts again (which in turn depends on when
it receives a signal). This is controlled by the trigger mode setting. When the channel power measurement,
total power measurement, average power measurement, average function, or power average function is
performed while “Single Measure ON” is set, the sweep is performed the specified number of times. (Note
there is no menu associated with this panel key.)
To Next Page
Loading...
Need help?
General
