ADVANTEST R3162 User Manual

R3132 Series Spectrum Analyzer Operation Manual
3.3.13 MEAS Key (Measurement)
3-47
Peak Delta Y Allows you to set the amplitude used for the peak search.
FM Meas OFF Turns the FM Meas function OFF.
1/2_more Displays the Measure menu (2/2).
Sound Displays the Sound menu, and demodulates the sound at the
marker.
Sound AM/FM Toggles between AM and FM demodulation.
Volume Allows you to set the demodulated sound volume. You can set the
sound volume from a range of 1 to 12.
Marker Pause Time Allows you to set the duration of the pause used during demodu-
lation.
Squelch ON/OFF Toggles the squelch function on or off.
ON: Displays the squelch marker which indicates that the
sound carrier level below this level is not demodulated.
The squelch level can also be changed.
OFF: Removes the squelch marker, and turns off the squelch
function.
Sound OFF Turns off the sound demodulation function.
Phase Noise Displays the Phase Noise menu.
A menu used to measure phase noises and phase jitters is dis-
played.
C/N Meas Displays the C/N Meas menu. A variety of settings for the phase
noise measurement can be performed. For this measurement, a
phase noise is calculated using an offset frequency which is devi-
ated from the carrier frequency or the current center frequency. A
maximum offset frequency of 10 points can be measured.
Edit Table Displays the Edit Table menu, allowing you to set the desired off-
set frequency.
Insert Enters the same data in the current cursor position.
Delete Deletes the data at the current cursor position.
Table Init
Deletes all data from the table.
Sig Track ON/OFF
Toggles the signal track mode on or off.

ADVANTEST R3162 Specifications

General

Brand	ADVANTEST
Model	R3162
Category	Measuring Instruments
Language	English