R3132 Series Spectrum Analyzer Operation Manual
3.3.16 PAS/FAIL Key (Pass/Fail Judgment)
3-55
TOP: Sets the vertical axis position using the limit line that is
set under Limit Line Edit as a relative value. The verti-
cal axis position of the limit line is fixed in the position
based on the top without being influenced by changes
in level setting.
BOT: Sets the horizontal axis position using the bottom of the
vertical axis as a relative value.
Sets the limit line property (in frequencies) along the vertical axis
(if OPT73, FM Demodulation function, is turned on).
ABS: The position along the vertical axis is determined from
the absolute value of a limit line set by the Limit Line
Edit.
The vertical position of the limit line varies according
to the change in the center frequency used.
CTR: The position along the vertical axis is determined rela-
tive to the limit line value set by the Limit Line Edit.
The vertical position of the limit line is fixed at its cen-
ter. Note that the center frequency does not affect the
vertical position of the limit line.
Shift X/Y Switches the offset direction for the limit line between X and Y.
X: Sets an offset value for the horizontal axis direction of
the limit line.
Y: Sets an offset value for the vertical axis direction of the
limit line.
Limit Line Edit Displays the Edit Menu.
Limit Line 1/2 Selects the limit line to edit on the Edit screen.
Insert Line Inserts a line in the cursor position.
Delete Line Deletes the line at the cursor position.
Sort Sorts the input data according to the frequencies.
Table Init Deletes all the data in the limit line setting table.
Copy Table 1 to 2 Copies the data created on limit line 1 to limit line 2.
Copy Table 2 to 1 Copies the data created on limit line 2 to limit line 1.
To Next Page
Loading...
Need help?
General
