134 Installation, Operation, and Maintenance
Part 2, Operation
7 Running Samples
Running a Priority Sample
Priority samples are for 6890 GCs only.
If the Use priority parameter is on in your GC sequence, the 7683 ALS tray
checks for a vial in position 100 before loading a new vial into the injector
turret. If it finds a vial there, it loads that sample vial into the turret and runs
it according to the method you assigned for priority samples.
When the priority sample run is completed, it returns the priority sample vial
to tray position 99, therefore keep this location empty when using this feature.
The tray gripper again checks vial position 100 and, if there is no vial there,
continues your original sequence from where it was interrupted. For more
information on how to program priority sequences, see your 6890 GC
documentation.
To Next Page
Loading...
Need help?
General
