25
Agilent 7683B Automatic Liquid Sampler
Installation, Operation and Maintenance
Agilent Technologies
2
Installation
The Installation Process 26
Procedure 1. Installing the G2916-61000 Injector Bracket 29
Procedure 2. Installing the G2916A Tray 35
Procedure 3. Installing the Injectors 42
Procedure 4. Connecting Cables 46
Procedure 5. Installing the G2911AA Software on the PC 50
Procedure 6. Installing the G2614A Tray 51
Procedure 7. Installing the G2615A Bar Code Reader 53
Procedure 8. Install the G2912A ALS Controller 55
Procedure 9. Replacing the Inlet Chassis Cover (6890A) 60
Procedure 10. Installing a G2612A Controller Board (6890 Plus) 61
Procedure 11. Configuring Your GC and Data System 65
Procedure 12. Updating the Firmware 66
Making A Trial Run 68
The procedures that you need depend on what GC you are mounting the
sampler on. To determine the appropriate procedures and order for your GC,
see Tables 4 through 8.
To Next Page
Loading...
Need help?
General
